2022–2024 Audi RS3 8Y Sedan Front Bumper Lip – Pre-Preg Dry Carbon Fiber

Upgrade the front end of your Audi RS3 8Y Sedan with this pre-preg dry carbon fiber front bumper lip. Finished in a high-polish gloss black 3K twill weave, it spans the lower front bumper to deliver a wider, more planted forward stance that sharpens the RS3's already aggressive front face.

Build

• Material: Pre-preg dry carbon fiber in a 3K twill weave — the resin is pre-impregnated into the weave under controlled conditions before curing, giving more consistent resin distribution, a tighter weave pattern, greater structural rigidity, and a lighter finished component than wet lay or vacuum wet carbon
• Manufacturing: 3D design and CNC moulding with pre-preg dry carbon construction
• Surface finish: High-polish gloss black finish that showcases the natural 3K twill weave with strong UV, moisture, and surface degradation resistance over long-term use
• Configuration: Single-piece lip for the lower front bumper

Design & Finish

• Aggressive stance: Lip profile adds width and a lower, ground-hugging forward stance for a more planted front end
• Full-width coverage: Spans the lower front bumper for an integrated finish with no exposed factory sections
• Carbon aesthetic: Refined 3K twill dry carbon weave and high-polish gloss finish complement the factory RS3 bodywork for a coordinated, motorsport-grade look

Fitment

• 2022–2024 Audi RS3 8Y Sedan (4-door)
• Fits the RS3 8Y factory front bumper only — not compatible with aftermarket or non-RS3 bumper configurations
• Not compatible with the standard A3 or S3 front bumper
• Body style: Sedan only — not confirmed for Sportback variants

Package Contents

• 1 × pre-preg dry carbon fiber front bumper lip
• Pre-applied adhesive tape for installation

Installation

• No-drill, adhesive-mounted: Installs with the included adhesive tape — no tools, no drilling, and no permanent modification to the factory front bumper
• Surface prep: Thoroughly clean, degrease, and dry the front bumper before fitting to ensure maximum adhesion
• Alignment: Dry-fit and check the lip sits centred and even across the bumper before final adhesion
• Professional installation recommended for correct panel alignment and finish quality given the panel's width

Before You Install

• Confirm your car is an RS3 8Y Sedan before ordering — fitment is not confirmed for the Sportback, and this will not fit the A3 or S3
• Work in moderate temperatures and allow the adhesive to cure fully before washing the car
• Front lips sit low and are exposed to kerbs, driveway ramps, and road debris — take care when parking nose-in
• Installation is reversible, but adhesive removal and re-prep may be required if the lip needs repositioning