

Why use a PRL Motorsports filter?
Our oiled filters are constructed from high quality, double layer cotton to increase the filtration surface by 10% - 15%. This causes air to move freely while maintaining superior filtration, trapping particles as small as 5 microns! The cotton filter is encased by coated steel mesh to ensure your PRL Motorsports air filter withstands the toughest of conditions!
Each filter is hand-molded using a flexible rubber base to ensure an airtight seal and absorb vibration. These filters do not use pressure-molding like other manufacturers, which can cause the rubber to seep into the filter element blocking airflow by up to 25%! Our air filters utilize a precision four-step process to virtually eliminate rubber seepage and maximize airflow!
Filter Dimensions:
Inlet:
4"
4"
Total Height:
7.25"
Filter Height:
6.375"
Flange Height:
.875"
Base Diameter:
5"
Top Cone Diameter:
4"
Filter Maintenance:
1.
|
PRE-CLEANING |
Tap the filter or blow with air to remove excess dirt. | |
2.
|
APPLY CLEANER |
Spray the filter with filter cleaner and allow the solution to soak in for about 15 minutes. * Never use strong detergents, high pressure water, or gasoline. |
|
3.
|
RINSE |
Rinse the filter with warm water, clean side to dirty side to flush out the dirt. | |
4.
|
DRYING |
Allow the filter to dry naturally. Try to avoid heat because it might shrink the cotton. | |
5.
|
APPLY OIL |
Re-oil the filter using filter oil by using 1 spray per 2 square inches of filter. Take care to not over-oil your filter. * Never use motor oil, transmission fluid, WD-40®, or any other brand of filter oil as these may damage your filter |